This is a magnetic holder for the common plastic egg crate (light diffuser) found in every hardware store. The notch on the screw allows for the insertion of the crate and the included screw clamps down on it. The slot is 2mm wide and fits most egg crates commonly found in most hardware stores. The diameter of the screw is 18mm so the egg crate cell needs to be bigger than 9mm (most, if not all, the crates commonly found are bigger than 12mm). The depth of the notch is 20mm which allows for the insertion of the crate and the screw to hold it tight. The magnets are pre-coated resin neodymium N50 high strength magnets capable of holding on less than 1/2″ glass (1/2″ will probably work).
- Printed out of PLA.
- Allows for holding of the most commonly found egg crates in the hardware store.
- The included screw clamps securely down on the crate holding it in place.
Depending on what you want to do, you most likely will want to buy a two pack of these to make sure there is balance and no tip overs. It is left entirely up to your discretion though.
*The egg crate is not included, it’s shown for reference.
* Clear color is essentially PLA with no added color. It’s translucent but not transparent (like glass or acrylic).
** When you choose “Other” as a color, please leave me a message in your order with what you like. Keep in mind that a color that I don’t have in hand will delay the shipping of your order by 2-3 business days so I can get the color in.